Decorazza Cera di Veneziano Nova

Surface preparation: The surface must be strong, clean, dry and free of grease. If necessary, sand the base Stucco Veneziano/Calce Veneziana with fine sandpaper. Remove remaining dust with a soft brush or vacuum cleaner. Application: 1. Before applying the decorative coating, protect unpainted areas with mounting tape and film. 2. Pre-apply Venetian plaster Stucco Veneziano, creating the desired pattern (see instructions for applying specified textured materials). 3. Before application, carefully mix the material Cera di Veneziano by hand. The material is ready for application. 4. Applying the material should begin from the upper left corner, moving to the lower right. To avoid noticeable joints on the surface, always work on a wet edge, leaving a minimum amount of material around the edges. 5. Apply the material with a trowel or stainless steel spatula in a thin layer over the surface to be stripped. Immediately begin polishing the surface. With force on the tool, with quick chaotic movements, smooth the surface with a spatula or mitten until the surface becomes glossy. Make movements when polishing carefully so as not to damage the thin finishing layer. 6. To obtain a mirror surface, polish the wax using a polishing machine with a nozzle made of soft material. Number of revolutions 2000 rpm. Perform the work the next day after applying wax. 7. Mixing with materials from other manufacturers is not allowed.