Decorazza Perla vernici

Surface preparation: The surface must be uniform, leveled, dry and clean. Remove existing weak parts and loose layers of old coatings. Smooth out cracks and chips using plaster or putty compounds. Sand the putty with fine sandpaper. Remove dust using a soft brush or vacuum cleaner. Application: 1. Before applying the decorative coating, protect unpainted areas with mounting tape and film. 2. Gently mix Perla Vernici material by hand before application. The material is ready for application. 3. Pre-apply textured material Barilievo ​​or another creating the desired pattern and texture (see instructions for applying the specified textured materials). After complete drying, if necessary, sand the textured base with fine sandpaper to create a smoother surface. Remove any remaining dust using a soft brush or vacuum cleaner. 4. Applying the material should begin from the upper left corner, moving to the lower right. To avoid noticeable joints on the surface, always work on a wet edge, leaving a minimum amount of material around the edges. 5. Application of material Perla Vernici as a glazing composition for the “Moroccan plaster” and “sea sponge” effects. Apply the material with a stainless steel spatula in small sections in different directions, as thin a layer as possible per tear. When working with the tool, it is necessary to apply a minimum amount of material to the edge of the spatula with an auxiliary tool. When working, it is necessary to periodically wipe the spatula with a rag to remove dried material to avoid scratches on the surface. 6. Application of material Perla Vernici as a glazing composition for the effects of “Provence”, “canvas”, “matting”. Apply the material with a mini brush in small sections in different directions. Immediately, without allowing the material to dry, it is necessary to remove excess material from the tops in a circular motion with a synthetic sponge or mitten, leaving it in the deeper parts of the textured coating. To achieve contrast, a synthetic sponge or mitten must be moistened while working. 7. Application of material Perla Vernici as independent paint. Pre-apply primer paint Base or high-grade paint Fiora, Silideco (see instructions for applying these materials). After the paint has completely dried, apply the material Perla Vernici with a stamp with pieces of artificial leather or a sea sponge using the padding method. Apply the material in small sections, constantly changing the direction of your hand in a circular motion. When working, the instrument must first be moistened with water and wrung out well. To tampon, take a small amount of material from the container with the material onto the instrument. Remove excess material from the tool using any flat surface, lightly tapping the tool against the surface. Remove excess material from the tool each time it is immersed in a container of material. Mixing with materials from other manufacturers is not allowed.