Decorazza Fleur Deco

Surface preparation: The surface must be uniform, leveled, dry and clean. Remove existing weak parts and loose layers of old coatings. Smooth out cracks and chips using plaster or putty compounds. Sand the putty with fine sandpaper. Remove dust using a soft brush or vacuum cleaner. Application: 1. Before applying the decorative coating, protect unpainted areas with mounting tape and film. 2. Gently mix Fleur Deco material by hand before application. The material is ready for application. 3. Application of material Fleur Deco ​​as independent paint. Pre-apply primer paint Base or high-grade paint Fiora, Silideco (see instructions for applying these materials). After the paint has completely dried, apply the material Fleur Deco with a stamp with pieces of artificial leather or a sea sponge using the padding method. Apply the material in small sections, constantly changing the direction of your hand in a circular motion. When working, the tool must first be moistened with water and wrung out well. For tamponing, take a small amount of material from the container with the material onto the instrument. Remove excess material from the tool using any flat surface, lightly tapping the tool against the surface. Remove excess material from the tool each time it is dipped into a container of material. 4. Application of material Fleur Deco as a glaze composition. Pre-apply textured material Barilievo, Elasticita, Sollievo, Traverata, Corteccia or another, creating the desired pattern and texture (see instructions for applying these textured materials). After complete drying, if necessary, sand the textured base with fine sandpaper to create a smoother surface. Remove any remaining dust using a soft brush or vacuum cleaner. Applying the material should begin from the upper left corner, moving to the lower right. To avoid noticeable joints on the surface, always work on a wet edge, leaving a minimum amount of material around the edges. Apply Fleur Deco with a mini brush in small sections in different directions. Immediately, without allowing the material to dry, it is necessary to remove excess material from the tops in a circular motion with a synthetic sponge or mitten, leaving it in the deeper parts of the textured coating. To achieve contrast, a synthetic sponge or mitten must be moistened while working. Mixing with materials from other manufacturers is not allowed.