Decorazza Protetto Matte

Important: The material must be applied as quickly as possible, but no later than 14 days after tinting. When applied to walls: Microcemento Fronte + Legante is suitable for application as a stand-alone material on pre-prepared concrete, cement, plastered brick substrates, plasterboard sheets, gypsum plaster and putty. The base must be homogeneous, level, dry, clean, without traces of oil. Remove existing weak parts and loose layers of old coatings. Smooth out cracks and chips using plaster or putty compounds. Sand the putty with fine sandpaper. Remove dust with a soft brush or vacuum cleaner. Before applying Microcemento Fronte + Legante, 1-2 layers of deep penetration primer Decorazza Primer (depending on absorbency) must be applied to the base, and then primer-paint Decorazza Primer di Quarzo. When applied to floors and furniture: Microcemento Fronte + Legante is applied as a finishing coat on a base made of Microcemento Struttura. Application: 1. Microcemento Fronte + Legante 1-3 layers are applied, depending on desired effect, onto the prepared surface using a trowel. ! It is necessary to monitor the pattern of each layer, because... it will appear on the finishing layer Microcemento Fronte + Legante. 2. Drying time between layers is 2-3 hours. If necessary, remove defects with 320-grit sandpaper. 3. 12-24 hours after applying the last layer Microcemento Fronte + Legante, sand with 320-grit sandpaper and remove dust. ! For instructions on applying the system Decorazza Microcemento to the floor and furniture, see the packaging Microcemento Struttura.