Decorazza Pastello vernici

Surface preparation: The surface must be strong, clean, dry and free of grease. If necessary, sand the textured base with fine sandpaper. Remove remaining dust with a soft brush or vacuum cleaner. Application: 1. Pre-apply textured material Romano, Traverta, Barilievo, Elasticita, Sollievo, Rustic, Corteccia, etc., creating the desired pattern and texture (see instructions for applying the specified textured materials). 2. After complete drying, if necessary, sand the textured base with fine sandpaper to create a smoother surface. Remove any remaining dust using a soft brush or vacuum cleaner. 3. Mix the material thoroughly before use. The material is ready for application. Apply material from the upper left corner moving towards the lower right. To avoid noticeable joints on the surface, work along a wet edge, leaving a minimum amount of material around the edges. 4. If the base has a pronounced textured pattern, apply the material with a mini brush or roller in small sections in different directions. Immediately, without allowing the layer to dry, use a synthetic sponge or mitten to remove excess material from the tops in a circular motion, leaving it in the deeper parts of the textured coating. 5. If the base has a less pronounced textured pattern, apply the material with a synthetic sponge or mitten in a circular motion, removing excess material from the tops and leaving it in the deeper parts of the textured coating. In both application options, to achieve contrast, a synthetic sponge or mitten must be wetted while working. 6. Mixing with materials from other manufacturers is not allowed.