Decorazza Art beton

Surface preparation: Apply to previously prepared mineral substrates: concrete, concrete blocks, brickwork, cement plaster, gypsum and plasterboard boards, etc. The surface must be uniform, level, dry and clean. Remove existing weak parts and loose layers of old coatings. Smooth out cracks and chips using plaster or putty compounds. Sand the putty with fine sandpaper. Remove dust using a soft brush or vacuum cleaner. Application: 1. Before applying the decorative coating, protect unpainted areas with mounting tape and film. 2. Treat the surface with deep penetration primer Primer using a roller and/or brush. 3. After the primer has completely dried, apply primer-paint Primer di Quarzo with a roller; the resulting surface has a slight roughness. After the first coat has completely dried, apply a second coat if necessary. Use a brush in hard-to-reach places. 4. Before application, if necessary, mix the material Art Beton mechanically. The material is ready for application. 5. Application of the material should begin from the upper left corner, moving to the lower right. To avoid noticeable joints on the surface, always work on a wet edge, leaving a minimum amount of material around the edges. 6. To enhance the decorative effect, it is recommended to use the following materials as a finishing layer: Cera Décor, Pastello Vernici, Cera di veneziano and other decorative materials Decorazza. Important! Apply the material at an air temperature of 15-25 ° C and a relative air humidity of no more than 65%. Mixing with materials from other manufacturers is not allowed.