Decorazza Brezza

Surface preparation: Apply to previously prepared mineral substrates: concrete, concrete blocks, brickwork, cement, cement plaster, gypsum, gypsum and plasterboard boards, etc. The surface must be homogeneous, leveled, dry and clean. Remove existing weak parts and loose layers of old coatings. Smooth out cracks and chips using plaster or putty compounds. Sand the putty with fine sandpaper. Remove dust using a soft brush or vacuum cleaner. Application: 1. Before applying the decorative coating, protect unpainted areas with mounting tape or film. 2. Treat the surface with deep penetration primer Primer using a roller or brush. 3. After the primer has completely dried, apply primer-paint Base with a lint roller, so that the surface is perfectly smooth, without a “fur coat”. To do this, roll the primer-paint Base in different directions over the surface. After the first coat has completely dried, apply a second coat if necessary. Use a brush in hard-to-reach places. It is recommended to tint the primer paint Base half a shade lighter than the topcoat. 4. Before application, carefully mix the material Brezza by hand. The material is ready for application. 5. Application of the material should begin from the upper left corner, moving to the lower right. To avoid noticeable joints on the surface, always work on a wet edge, leaving a minimum amount of material around the edges. 6. Apply the material in small sections on the dried base paint, approximately 1-2 square meters, using a mini-brush, in multidirectional chaotic movements, or in a given horizontal or vertical direction. 7. At the same time, without allowing the material to dry, use light brush movements to form the desired pattern or direction of the quartz filler particles. 8. Apply the material at an air temperature of 15-25 ° C and a relative air humidity of no more than 65%. 9. Mixing with materials from other manufacturers is not allowed.