Decorazza Seta Bianca

Surface preparation: Apply to previously prepared mineral substrates: concrete, concrete blocks, brickwork, cement, cement plaster, gypsum, gypsum and plasterboard boards, etc. The surface must be uniform, level, dry and clean. Remove existing weak parts and loose layers of old coatings. Smooth out cracks and chips using plaster or putty compounds. Sand the putty with fine sandpaper. Remove dust using a soft brush or vacuum cleaner. Application: 1. Before applying the decorative coating, protect unpainted areas with mounting tape or film. 2. Treat the surface with deep penetration primer Primer using a roller or brush. After the primer has completely dried, apply primer-paint Base with a short-nap roller, so that the surface is perfectly smooth, without a “fur coat.” To do this, roll the primer-paint Base in different directions over the surface. 3. After the first coat has completely dried, apply a second coat if necessary. Use a brush in hard-to-reach places. It is recommended to tint the primer paint Base half a shade lighter than the topcoat. 4. Before application, carefully mix the material Seta by hand. The material is ready for application. Applying the material should begin from the upper left corner, moving to the lower right. To avoid noticeable joints on the surface, always work on a wet edge, leaving a minimum amount of material around the edges. 5. When working with the tool, it is necessary to apply a small amount of material to the edge of the trowel with an auxiliary spatula. Try to maintain the same layer thickness on all layers without creating texture. 6. To create the effect of smooth silk, apply the first layer to the dried primer-paint with a trowel using multidirectional strokes in small areas. Level the material with a trowel at a slight angle to the surface. Apply the second layer in small sections in opposite directions creating a pearlescent shimmer. To do this, use the surface of the trowel, leaving a small gap between the surface to be treated and the tool, to distribute the material in uniform strokes. It is important that the pattern of strokes of the second layer does not repeat, but “intersects” with the pattern of the first, since the first layer will shine through, creating the depth of the pattern. 7. To create the effect of draped fabric, apply the material to the dried primer-paint with a trowel in multidirectional strokes in small areas. Immediately, without allowing the material to dry, begin to form a pattern using the flat of the trowel in a circular motion in different directions. Try to make movements smooth, without pressing too hard on the instrument. If you need to create a whiter, finer pattern, wait until the material begins to become more matte (dry), but still has the characteristic shine of undried material. At this point, repeat the circular movements described above. 8. Material Seta can be used as an additional decorative layer on textured materials Decorazza. 9. Apply the material at an air temperature of 15-25 ° C and a relative air humidity of no more than 65% 10. Mixing with materials from other manufacturers is not allowed.